f9488a8cf8 If the switch is then powered off, it resets the VTP configuration to the default. VTP: domain test, current rev = 0 found for summary pkt VTP: summary packet rev 11 greater than domain test rev 0 !–- This configuration revision is higher than that on bing. SupportTechnology SupportLAN Switching Configuring VLAN Trunk Protocol (VTP) Download Print Available Languages Download Options PDF (19.2 KB) View with Adobe Reader on a variety of devices Updated:Sep 24, 2014 Document ID:98154 Contents Introduction Prerequisites Requirements Components Used Conventions Understand VTP VTP Configuration Guidelines VTP Configuration on Catalyst Switches Catalyst 6500/6000 Series Cisco IOS Software/Catalyst 4500/4000 Cisco IOS Software (Supervisor Engine III/Supervisor Engine IV), Catalyst 2950, 3550, and 3750 Series Switches Catalyst 4500/4000, 5500/5000, or 6500/6000 Series CatOS Catalyst 2900XL, 3500XL, 2950, and 3550 Catalyst Express 500 Series Switches Practical Examples Troubleshoot VTP Related Information Introduction This document provides information on how to configure VLAN Trunk Protocol (VTP). The option to turn VTP on or off on a per-trunk (per-port) basis. Note:Trunk negotiation does not work across VTP domains.
You must configure these VLANs manually on each device. In VTP versions 1 and 2, the switch must be in VTP transparent mode when you create extended-range VLANs. The user must manually configure all VLANs that are used on the switch. VTP version 3 does support private VLANs. You cannot convert from VTP version 3 to VTP version 2 if extended VLANs are configured in the domain. Turn off VTP pruning by making all VLANs on the trunk of the switch upstream to the VTP transparent switch pruning ineligible. Instead, the key associated with the password is saved in hexadecimal format in the running configuration. Exiting. VTP Advertisements Each switch in the VTP domain sends periodic global configuration advertisements from each trunk port to a reserved multicast address.
Hanpar replied
456 weeks ago